Back to Blog
Bluetooth remotehelper page timeout5/24/2023 Via ssh, using bluetoothctl, a similar error is returned:Īnd removal of the existing entry, both fail: $ bluetoothctl This made no difference: sudo apt-get remove pi-bluetooth 'Remove Bluetooth device' (no error is shown, but the entry persists).īluetooth is not disabled in /boot/config.txt #disable onboard bluetoothĪt the command line, after exiting ES, I uninstalled and reinstalled bluetooth, then rebooted. It is not possible to remove the existing entry via 'Register and Connect to Bluetooth device' returns: (Creating device failed: )Ī previously working Xbone One S controller (which I unpaired a while ago) is not detected by this process. Within EmulationStation, in the RetroPie | Bluetooth configuration tool, the bluetooth keyboard which previously worked is still registered, but will no longer pair. Hardware is a Raspberry Pi 3 (original model) sudo uname -a You can also disable MAC address filtering.I'm having problems with a Bluetooth keyboard, and BT in general, on an up-to-date Retropie installation where it previously worked fine. If wireless MAC address filtering is enabled for the router, remove your device from the router's MAC address filtering list to ensure that it is allowed to connect to the network. You can disable a device's Wi-Fi feature to reserve the channel for resource reallocation. If the network is normal but the device network connection still fails, check whether the router is overloaded.Troubleshooting: Download the Internet Speed Test App ( make sure the phone is connected to the 2.4GHz network ), place your mobile phone in the same location as the device, and then test the Internet upload and download speed at that location ( ensure that the speed is at least: upload ≥ 2 MB/s, download ≥ 2 MB/s or upload ≥ 16 Mbps, download ≥ 16 Mbps ), smart camera equipment occupies a large amount of upload bandwidth, and at least 4M of upload bandwidth is required for 1080p image quality ( 0.5MB/s, 4Mbps ), if your device has enabled the cloud storage function, additional 2M upload bandwidth is required, please confirm that your network has sufficient network bandwidth. Please make sure that the signal of the network environment where the device is located is strong and stable.If you are informed that the device has been bound to another account during the binding process, please follow the instructions on the posted page to unbind the device and add it again.IIf you are using iOS 14 and above, please make sure you have opened the local network permission and wireless data permission of the App. The "Auto Scan" method may not be able to add your Wi-Fi device.
0 Comments
Read More
Leave a Reply. |